Lincoln Electric IM713-B Manuel d'utilisateur télécharger pdf (Page 21)

B-4

OPERATION

POWER WAVE® 655/R

B-4

CASE FRONT CONTROLS

All operator controls and adjustments are located on

the case front of the Power Wave®. (See Figure B.1)

1. POWER SWITCH: Controls input power to the

Power Wave®.

2. STATUS LIGHT: A two color light that indicates

system errors. Normal operation is a steady green

light. Error conditions are indicated per table 4.

NOTE: The robotic Power Wave’s® status light will

flash green, and sometimes red and green, for up to

one minute when the machine is first turned on. This

is a normal situation as the machine goes through a

self test at power up.

TABLE 6

Light

Condition

Steady Green

Blinking

Green

A l t e r n a t i n g

Green and

Red

Steady Red

Blinking Red

Meaning

System OK. Power source communicating normal-

ly with wire feeder and its components.

Occurs during a reset, and indicates the PW-

655/R is mapping (identifying) each component

in the system. Normal for first 1-10 seconds

after power is turned on, or if the system con-

figuration is changed during operation.

Non-recoverable system fault. If the PS

Status light is flashing any combination of

red and green, errors are present in the PW-

655/R. Read the error code before the

machine is turned off.

Error Code interpretation through the Status

light is detailed in the Service Manual.

Individual code digits are flashed in red with

a long pause between digits. If more than

one code is present, the codes will be sepa-

rated by a green light.

To clear the error, turn power source off, and

back on to reset. See Troubleshooting

Section.

Not applicable.

3. HIGH TEMPERATURE LIGHT (thermal overload):

A yellow light that comes on when an over temper-

ature situation occurs. Output is disabled until the

machine cools down. When cool, the light goes out

and output is enabled.

4. 10 AMP WIRE FEEDER CIRCUIT BREAKER:

Protects 40 volt DC wire feeder power supply.

10 AMP AUXILIARY POWER CIRCUIT BREAKER:

Protects 110 volt AC case front receptacle auxiliary

supply.

6. LEAD CONNECTOR S2 (SENSE LEAD)

7. 5-PIN ARC LINK S1

8. 5-PIN DEVICENET CONNECTOR S5

9. I / O CONNECTOR

10. NEGATIVE STUD

11. INTERFACE CONNECTOR S6

12. POSITIVE STUD

13. AUXILIARY OUTPUT

POWERWAVE

STUD

SENSE

LINK

Case Front Layout

Power Wave 655/R (Domestic/Canadian Version)

FIGURE B.1

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Lincoln Electric IM713-B Manuel d'utilisateur Page 21

Commentaires sur ces manuels

Produits connexes et manuels pour Système de soudage Lincoln Electric IM713-B