Lincoln Electric LN-8 SVM132-A Manuel d'utilisateur télécharger pdf (Page 29)

B-5

OPERATION

B-5

WIRE FEED ROLLS AND GUIDE

TUBES

The drive rolls and guide tube kits are ordered sepa-

rately. Refer to Figure B.3 and install these parts per

the following instructions:

1. Loosen the idle roll spring pressure screw.

2. Remove the drive roll screw and clamping collar

from the drive shaft.

3. Install the drive roll and replace the clamping col-

lar. Tighten the drive roll screw.

4. Remove idle roll shaft screw. Install the idle roll

and idle roll shaft screw.

5. Remove the large ingoing guide from the rear

brass block by loosening the locking screw.

6. Loosen the ingoing guide tube clamping screw.

Install the ingoing guide tube (which is stenciled

“in”) through the rear brass block. Tighten the

clamping screw.

LN-8

Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC

Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC

FIGURE B.3 – WIRE FEED ROLLS AND GUIDE TUBE INSTALLATION

LOCKING

SCREW

OUTGOING

GUIDE TUBE

CLAMPING

COLLAR

DRIVE

ROLL

DRIVE

ROLL

SCREW

INGOING

GUIDE

TUBE

CLAMPING

SCREW

LOCKING

SCREW

LARGE

INGOING

GUIDE

IDLE ROLL

SPRING PRESSURE

SCREW

IDLE

ROLL

IDLE ROLL

SHAFT SCREW

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 98 99

Commentaires sur ces manuels

Pas de commentaire

Lincoln Electric LN-8 SVM132-A Manuel d'utilisateur Page 29

Commentaires sur ces manuels

Produits connexes et manuels pour Système de soudage Lincoln Electric LN-8 SVM132-A