Lincoln Electric LN-8 SVM132-A Manuel d'utilisateur télécharger pdf (Page 89)

F-39

TROUBLESHOOTING AND REPAIR

F-39

14. Install the gearbox assembly onto

the insulation sheet and mounting

plate using four hex head screws,

lockwashers and flat washers.

Ensure that the edge of the mount-

ing plate that has the single

mounting hole is under the drive

motor.

15. Place the wire drive assembly into

the case. Secure the wire drive

assembly using three round head

screws and lockwashers.

16. Position the reed switch bracket

onto the front of the wire drive

assembly and tighten the two hex

head screws that secure it in

place. Refer to Figure F.12.

17. Connect the two #567 (blue) leads

and the #568 (blue) lead to the

shunt. Note lead placement. Refer

to Figure F.13.

18. Connect the #528 wire (yellow)

from the drive motor to the reed

switch wire and gun receptacle

wire (both #528 blue) using the

round head screw and nut. Wrap

the connection in insulating tape.

Refer to Figure F.11.

19. Connect the drive motor wire #525

(yellow) to the ground lead protec-

tion wire at the in-line connector.

20. Connect the drive motor ground

lead (green) to the case.

21. Connect the drive motor leads

#539 (blue) and #541 (black) to

the back of the Control PC board.

22. Connect drive motor leads #626

(red) and #627 (white) to the side

of the Relay PC board.

23. Install the screws that secure the

left side cover assembly.

WIRE DRIVE ASSEMBLY AND COMPONENT REPLACEMENT (continued)

LN-8

Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC

Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 98 99

Commentaires sur ces manuels

Pas de commentaire

Lincoln Electric LN-8 SVM132-A Manuel d'utilisateur Page 89

Commentaires sur ces manuels

Produits connexes et manuels pour Système de soudage Lincoln Electric LN-8 SVM132-A